Vega VEGAWAVE 61 Series Vibrating Level Switch Vibrating Level Switch, Relay Output, Cable, ATEX-Rated

The Vega vibrating level switch has a relay (DPDT) output. It is energized by a piezo crystal and it vibrates at a fixed amplitude. If the vibrating rod is covered by the product, the amplitude change is detected by the integral electronics and converted into a switch signal. The switching condition is visible from outside via a two-colour LED. Vibrating Liquid/Solid Level Probes - Squings.
All of these probes are maintenance-free and have an external LED switch status indication.

The supply voltage ranging from 20VAC to 253VAC and 20VDC to 72VDC
Process fitting material is thread G1 PN25, DIN3852-A

Easy setup without adjustment
Product-independent switching point
Rugged sensor construction
Insensitive to build-up and statically charged products
Solid densities from 8g/l reliably detected
maintenance-free and does not wear out easily
External LED switch
Housing material PBT (plastic)
Density is greater than 100g/l
Breaking capacity maximum 750VA, 54W

Typical applications are overfill and low-level detection in media like grain, fine aggregates, sand and heavier powders such as cement and metal oxides
Almost all the bulk solids applications

IP66 rated
IP67 rated
ATEX II 1/3 D IP6X T